 |  | 
  
The Pelco EH3512, EH3512-1, EH3512-2 environmental housings are a low-cost camera enclosure constructed from die cast and extruded aluminum. The lower body length is 12.75 inches (32.38 cm). This housing is used for 2/3", 1/2" and 1/3" format cameras and fixed focal length lenses or motorized zoom lenses. The front hinged lid provides easy access to the removable camera sled. Two adjustable glands on the bottom of the enclosure allow for easy installation of the power and video cables. The rear link-lock latch can be used with a padlock of suitable size to secure the enclosure.
Maximum Camera Size (Including Lens and BNC Connector):
EH3512
2.87" W x 3.00" H x 10.25" L
7.28 cm x 7.62 cm x 26.03 cm
EH3512-1, EH3512-2, EH3512-3
2.87" W x 3.00" H x 9.00" L
7.28 cm x 7.62 cm x 22.86 cm
Product Features
Latch Link-lock No. 3, stainless steel; can be
secured with padlock not supplied.
Heater & blower optional select below.
Spec Sheet in PDF format

|
 | |  | Heater & Blower Specifications
 Thermostatically controlled heater & blower will be factory installed before shipping. EH3512-1 & EH3515-1 Blower, continuous duty.
Blower
120 VAC
3.8 watts
10 cfm @ 60 Hz.
Heater
thermostatically controlled,
120 VAC
11 watts
Activates ON at
50°F (10°C); OFF at 80°F (26.67°C)
EH3512-2 & EH3515-2 Blower kit, continuous duty, 24 VDC
(AC rectified), 1.92 watts, 19 cfm @
50/60 Hz. Heater same as 120VAC model except 24VAC

|  |  |  |  | 24VAC 50VA Power Supply
 Plug-in camera power supply for a single camera and or housing. Equipped with power LED.

|  |
|